Feed Equipment Knowleagde

  • Safety-tips-for-using-Feed-Crushing-machine

    Safety tips for using Feed Crushing machine
    1. Long-term operation should be fixed on the basis of cement. If the working place is changed frequently, the pulverizer and the motor should be installed on the frame made of angle iron. If the pulverizer is powered by diesel, the power of the two should be matched, that is, the diesel engine power is slightly larger than the pulverizer power, and both The pulley grooves are the same, and the outer end faces of the pulleys are on the same plane.
    2. After the pulverizer is installed, check the fastening condition of each fastener. If it is loose, it must be tightened.
    Third, check whether the belt tightness is appropriate, and whether the motor shaft and the pulverizer shaft are parallel. 4. Before starting the pulverizer, first turn the rotor by hand to check whether the teeth, hammer and rotor are running flexibly and reliably. There is no collision in the shell. The direction of the rotor is consistent with the direction indicated by the arrow on the machine. Motor and powder Whether the machine lubrication is good.
    5. Do not change the pulleys casually, in case the rotation speed is too high, the explosion chamber will explode, or the rotation speed will be too low, which will affect the working efficiency.
    6. After the pulverizing table is started, it will be idling for 2 to 3 minutes. After there is no abnormal phenomenon, it will be put into operation.
    7. Attention should be paid to the operation of the pulverizer at all times during the work. The feeding should be uniform to prevent the stagnation of the car and not to overload the machine for a long time. If vibration, noise, high temperature of the bearing and the body, and external spraying are found, stop the machine immediately and continue working after troubleshooting.
    8. The crushed materials should be carefully inspected to prevent accidents such as copper, iron, stones and other hard objects entering the crushing room.
    Nine, the operator should not wear gloves, should be standing on the side of the crusher when feeding, in order to prevent rebound debris from injuring the face.
    10. When clogging, it is strictly forbidden to forcibly feed or tow the feed by hand or wooden stick.

    Leave a message