Feed Equipment Knowleagde

We pay attention to adjusting the feed crushing mechanical hammer and sieve plate during the operation of the feed crushing process, and these fittings must be in the best position during operation. The first is the adjustment of the hammer of the feed crushing machine. There are four sets of hammers in the rotor, and the hammers are arranged symmetrically. Therefore, the hammer must be installed strictly in strict installation requirements. The difference between the two sets of hammers should not exceed 5 grams (ie, one weight). In the first corner of the hammer, the direction of the feed guide can be reversed. Turn, use the second corner of the hammer to work. When the second corner is also worn, the hammer is turned around. Work with its third corner. In order to keep the automatic feed mill in balance, all hammers must be turned at the same time. After the third triangle wears, the rotor is reversed and the fourth corner is used to work. Thus, one hammer and four corners can work. When all four corners are worn, the hammer must be updated.

The adjustment of the sieve plates is also very important. According to the fineness of the pulverized material, the sieve plate of the corresponding sieve hole is used first. After the sieve plate is worn or damaged, it is necessary to replace the new sieve plate in time. The sieve plate is loaded from the operation door on both sides and is pressed by the operation door. The adjustment of the hammer and the sieve plate of the feed crushing machine ultimately serves the efficiency of the crusher and the economic benefit of the manufacturer, so it is especially necessary to master the effective adjustment method.

In addition, when we buy the feed mill, we need to observe some of its parameters. These parameters are also the standard we purchased. We can compare the target parameters of the purchase with the parameters of the mill to be seen. The machine does not meet our production needs.